Control Features; Manual Choke Lever; Throttle Lever; Brake Controls - DAELIM ET-300 - SERVICE MANUAL BIS Service Manual

DAELIM

Manual Choke Lever

MANUAL CHOKE LEVER
The ET250 are equipped with a manually
operated carburetor choke system.
This choke is operated by the lever at the bottom
of the left hand control switch.
When first starting the engine,(cold start), place
the lever in the full left position, (Choke closed
or on) As the engine warms return the lever to
the full right position. (Choke open or off).

THROTTLE LEVER

The throttle lever is located on the right-hand
handle bar below the grip. To operate the
throttle lever, place your right thumb on the
lever and press forward to increase your speed.
To decrease your speed, reduce your pressure
on the lever and the spring tension will
automatically reduce your speed.
Throttle

CONTROL FEATURES

The travel of the throttle lever is controlled by
the throttle stop bolt.
As your operator gains more experience, you
can increase the throttle travel to allow for
additional speed to be obtained.
To increase the throttle's travel, thus
increasing the maximum speed, turn the
throttle stop bolt counter clockwise. To
decrease the throttle's travel, thus decreasing
the maximum speed, turn the throttle stop bolt
clockwise.
The throttle cable should be adjusted so there
is 2mm, (1/8") free travel at the lever before
the throttle starts to open.
This vehicle is equipped with dual front
hydraulic disc brakes and a rear hydraulic
disc brake.
The front brakes are controlled by the long
brake lever on the right-handle bar.
03
Throttle Stop
Adjustment Boit

BRAKE CONTROLS