Fuel System; Fuel Tank; Fuel Valve - DAELIM ET-300 - SERVICE MANUAL BIS Service Manual

3. Also,as you found out the parking brake
ability which is a bit insufficient, you can
screw the adjustable nut of parking brake.
Parking Brake Adjustable Bolt Parking Brake Adjustable Bolt
Parking Brake Adjustable Nut Parking Brake Adjustable Nut

FUEL SYSTEM

Fuel Tank

The fuel tank fill cap is located on top of the
unit just ahead of the seat. The cap contains a
vent to prevent a vacuum from forming in the
tank as fuel is used. The vent tube must be
attached to the cap and inserted in the vent
tube holder hole while operating the unit. The
fuel cap vent and vent tube must be clean and
clear of obstructions for the unit to operate
normally. You can check the vent and vent
tube by blowing air through the tube. If you can
not blow through the vent tube and cap you
must clean the vent and tube or replace them.
Fuel Tank Cap
& Vent Line
Every time you refuel your unit, check the
rubber seal inside the cap for cuts, tears and
dirt. Clean or replace the seal if it becomes
worn or torn. The seal must be in good
condition to insure a proper seal of the cap to
the tank to prevent fuel spills. DO NOT allow
dirt or other debris to enter the tank when
refueling.
Replace the cap if damaged or if it will not seal
to the tank.
Tighten the cap snugly, being careful not to
over tighten. Over tightening the cap can
CONTROL FEATURES
cause damage to the cap or seal.
The fuel tank capacity is 12 liters, 3.17 gal,
including a reserve of 2.5 liters, 0.66 gal.
Use unleaded automobile gasoline with an
octane level of 91 or higher.
Your ATV is equipped with a fuel gage located
in the instrument cluster between the handlebars.
NEVER REFUEL YOUR ATV when the
engine is HOT. Wait 30 minutes after turning
off the unit before refueling. Spilling fuel on a
HOT engine could cause a fire. Wipe up any
fuel spills before re-starting.
The unit is equipped with a three way fuel
valve located on the left side of the unit just
below the seat.
The valve has three settings; "ON", "RES"
and "PRI".
Place the valve in the "ON" for normal operation
of the unit.This allows fuel to flow to the
carburetor for normal operating. The "RES"
position allows fuel to flow from the small
reserve in the tank to allow the unit to be
taken to a refueling location. When you have
to switch to the "RES" position you must refuel
the unit as soon as possible.
When the fuel valve set on the "ON" or "RES"
position, the unit is equipped with a vacuum
controlled fuel valve. The fuel supply is autom

Fuel Valve

PRI
ON
RES
Fuel Line
Vacumn Control
Line