F r e i g h t l i n e r - a l l . b o o k P a g e 1 7 6 M o n d a y , D e c e m b e r 1 , 2 0 0 3 2 : 5 4 P M
1 7 6 S T A R T I N G A N D O P E R A T I N G
• Open immediately the water drain screw (3) about 1
turn (counterclockwise) until fluid emerges. Ensure
that the fluid is collected in the receptacle.
• Close the water drain screw (3) as soon as about 0.25
US qt (0.2 liters) are emerged.
• After draining, return the key in the ignition lock to
position 0.
• Dispose of the collected fluid in an environmentally
responsible manner.
• If the filter is still saturated, drain the filter once
more.
After draining, the engine may run briefly but stall for
lack of fuel. If this occurs, bleed the system.
NOTE: Should the water in the fuel indicator lamp
still not go out after the fuel filter has been drained
twice, the cause should be examined by an authorized
Sprinter Dealer.
B l e e d i n g t h e D i e s e l F u e l S y s t e m
The diesel fuel system is bled before starting the
engine.
• Turn the key in the ignition lock position 2 for at
least 30 seconds.
• Return the key to position 0.
• Start the engine three to four times. The engine
control unit indicator lamp ± must go out.
NOTE: Too many attempts to start the engine could
drain the battery. If the engine does not start after
several attempts, consult an authorized Sprinter
Dealer.