3
4
5
6
7
8
9
Specifying operating system support
You can install the custom installation packages that you create with Symantec
Packager on all supported operating systems. If the custom command is limited
to specific platforms, you must specify this information when you configure the
custom command.
Browse to the files that you want to add to the custom command, and then
click Open.
Press and hold down the Ctrl key to add multiple files at once.
In the Command Editor dialog box, on the Parameters tab, click Target path
for additional files, and then click Modify.
In the Target path for additional files dialog box, select the location on the
target computer to which you want to copy the optional files as follows:
Program Files
Copies the files to the Windows Program Files directory
directory
Root of system drive Copies the files to the root of the system drive
Custom path
Copies the files to the specified path
Unspecified target
Copies the files to the user's temp directory
location
Under Folder specification, type a folder name to use in conjunction with
the selection that you chose in step 5.
Symantec Packager previews the target location under Sample path.
Click OK.
In the Command Editor dialog box, do one of the following:
Click OK to save your changes and close the Command Editor dialog
■
box.
Click Apply to save your changes and continue configuring the
■
command.
If prompted, type a file name, and then click Save.
Configuring custom commands
Configuring custom commands
55