Table of Contents
Advertisement
52 Configuring custom commands
Configuring custom commands
Enter a command-
line argument to
execute a
command on the
target system
Specify files and
their target
locations to copy
files to the target
system
Combine a
command-line
argument and
additional files to
deploy and
execute files on
the target system
Specifying command-line parameters and switches
Figure 8-2
Command Editor dialog box: Parameters tab
Symantec Packager lets you configure a custom command that includes a
command-line argument and the additional switches to use when the command
runs.
Symantec Packager also lets you define optional switches that you can use
during a silent, passive, or interactive package installation. You must specify the
information that Symantec Packager needs to install and run the command and
any variables that you want to use.
To specify command-line parameters and switches
1
In the Symantec Packager window, on the Configure Products tab, do one of
the following:
Create a new custom command.
■
Double-click an existing command to edit it.
■
Advertisement
Table of Contents
