Stand-Alone Inventory Package Command-Line Switches - Symantec ALTIRIS INVENTORY SOLUTION 7.0 SP2 - V1.0 Manual

66 Gathering inventory using stand-alone packages

Stand-alone inventory package command-line switches

Stand-alone inventory package command-line
switches
When you run a stand-alone inventory package, the package uses the options that
are selected when the package was created. When you run a package, you can use
command-line switches to modify default behavior.
See "Stand-alone inventory package options page "
See "Running stand-alone inventory packages on target computers"
These switches are not case sensitive.
Stand-alone inventory package command-line switches
Table 5-4
Command-line switch
/EnableVerboseLog
/SendChangedInventory
Description
By default, all the errors are logged. If you specify
/EnableVerboseLog at the command line, it enables verbose
logging. If verbose logging is enabled, the trace messages
are also logged.
By default, a stand-alone inventory package reports all the
gathered inventory. If you use this switch, the package
reports only the inventory data that has changed since the
last scan.
To gather only changed data, the package compares the
previously collected data, if the previous data was cached.
To cache inventory data, check Keep the inventory cached
for future comparisons in the package configuration page.
For more information, see See
stand-alone inventory packages"
If no previous inventory data is present, all gathered
inventory is reported.
If you have multiple Notification Servers, do not use this
option if you report data to a server that does not have the
previous data stored on it.
on page 61.
on page 64.
"Creating and editing
on page 60.