List Of Messages - Canon 2486B001 Instruction Manual

Additional Information
Playback
During playback there is video noise.
- Video heads are dirty. Clean the video heads (
Playback does not start.
- Load a cassette (
- Set the camcorder to
- Tape reached the end ("
No sound from the built-in speaker.
- Open the LCD panel.
- Speaker volume is turned off. Adjust the volume with the [SPEAKER VOLUME] setting (
Image will not appear on the TV screen.
- Check again that the camcorder is properly connected to the TV (
Tape is running, but image will not appear on the TV screen.
- TV/VIDEO selector on the TV is not set to VIDEO. Set the selector to VIDEO (
- Video heads are dirty. Clean the video heads (
- You attempted to play back or dub a copyright protected tape (
Editing
Cannot record with this camcorder video input from an external video device connected using a DV cable.
- Wrong signal standard. Refer also to the instruction manual of the connected device.

List of Messages

(in alphabetical order)
CHANGE THE BATTERY PACK
- Battery pack is exhausted. Replace or charge the battery pack (
CHECK THE CASSETTE [AUDIO MODE]
- You attempted to dub audio (
CHECK THE CASSETTE [BLANK]
- You attempted to dub audio (
CHECK THE CASSETTE [INCORRECT TAPE SPECIFICATION]
- You attempted to dub audio (
CHECK THE CASSETTE [REC MODE]
- You attempted to dub audio (
64
27).
( 33).
END" appears on the screen). Rewind the tape (
53) on a tape recorded with an audio mode other than [
53) on a tape with a blank section.
53) on a tape recorded in HD (high definition) standard.
53) on a tape recorded in a recording mode other than SP.
2).
49).
2).
52). Stop playback/dubbing.
17).
27).
34).
50).
12bit].