Returning To A Pre-Marked Position; Locating The Beginning Of A Recording Date - Canon 2486B001 Instruction Manual

Returning to a Pre-marked Position

If you wish to return to a particular
scene later, mark the point with the zero
set memory and the tape will stop at
that point when you rewind/fast forward
the tape. This function is operated with
the wireless controller.
(
1
While recording or during
playback, press
at the point you wish to return to
later.
• The time code changes to
"0:00:00 ".
• Press
ZERO SET MEMORY
cancel the memory.
2
If you marked the zero memory
while recording, set the
camcorder to
you marked the zero memory
during playback, press
3
Press to locate the zero mark.
• If the tape counter shows a
negative number, press
instead.
• appears and the camcorder
rewinds/fast forwards the tape.
• The tape stops at or near the zero
mark, disappears and the
correct time code will be displayed
again.
NOTES
If there are blank sections between
recordings, the zero set memory may not
work correctly.
21)
ZERO SET MEMORY
again to
mode. If
STOP
.
Locating the Beginning of a Recording
Date
You can locate the change of the date/
time zone with the date search function.
(
Press or
controller.
• Press more than once to search for
further date changes (up to 10 times).
• To cancel the search press
NOTES
• The date search function will not detect
recordings shorter than 1 minute per
date/time zone.
• Date search may not function if the data
code is not displayed correctly.
21)
on the wireless
STOP
.
35