Chapter 4. Post-Installation Settings; Setting The Program By Default - KAPERSKY ANTI-VIRUS 5.0 - FOR LINUX FREEBSD-OPENBSD MAIL SERVER Administrator's Manual

CHAPTER 4.
POST-INSTALLATION
SETTINGS
During installation, the system onto which you install Kaspersky Anti-Virus
analyzed and some of its configuration parameters are set automatically. A
number of parameters of the configuration file are set by default as the most
suitable for the operation of the anti-virus program (see section 4.1 on page 31).
Before you begin using the product, we advise that you install or update
the anti-virus database if it was not done during the installation, and
scan the server's file systems for viruses!
However, this is not sufficient to begin working with the program. You need to do
the following:
Integrate Kaspersky Anti-Virus
server.
Create a list of licensed users whose incoming and outgoing mail will be
scanned for viruses and disinfected.
In addition, we recommend doing the following:
Set up joint operation of Kaspersky Anti-Virus
Set up administrator's notification regarding forthcoming expiry of the
license for use of Kaspersky Anti-Virus
TRAFFIC LIMITATION license.
We also advise that you set up joint operation of Kaspersky Anti-Virus
Webmin package.
In this chapter, we shall describe the default setting of Kaspersky Anti-Virus
take an in-depth look at the configuration required to use the product.

4.1. Setting the program by default

All the parameters of Kaspersky Anti-Virus
the file kav4mailservers.conf. This is the default configuration file.
®
with the mail system installed on your
®
with the Webmin package.
®
if it was purchased under a MAIL
®
for Unix Mail Servers are stored in
®
is
®
with the
®
and