Table of Contents
Advertisement
Attention:
the server is powered-on might cause the server to halt, which could result in the
loss of data. To avoid this potential problem, always use an electrostatic-discharge
wrist strap or other grounding system when working inside the server with the
power on.
To install a hot-plug PCI or PCI-X adapter, complete the following steps.
Note: For hot-pluggable adapters, make sure that the PCI hot-plug device driver is
installed.
1. Read the safety information that begins on page v and "Installation guidelines"
2. If the adapter is not hot-pluggable, turn off the server and peripheral devices,
3. Remove the server cover (see "Removing the cover and bezel" on page 23) and
4. See the documentation that comes with the adapter for instructions for setting
5. Install the adapter:
28
IBM System x3950 Type 8872 and System x3950 E Type 8874: User's Guide
Static electricity that is released to internal server components when
on page 21.
and disconnect the power cords and all external cables.
determine which PCI-X expansion slot you will use for the adapter.
PCI-X retaining
PCI-X
bar
divider
jumpers or switches and for cabling.
Note: Route adapter cables before you install the adapter.
a. Open the blue PCI-X retaining bar by lifting the front edge.
b. Push the orange adapter retention latch toward the rear of the server and
open the tab. The power LED for the slot turns off.
c. Remove the expansion-slot cover.
Attention
Tab
LED
(yellow)
Power
LED
(green)
Adapter
retention
latch
Advertisement
Table of Contents
