Dell PowerEdge 2410 Installation Manual page 19

Locate the top bolt hole in the right side of the rack, and fasten the
g
hinge body to the right side of the rack with the Allen bolt.
Insert the spring between the top and bottom hinge-pin holes in the
h
hinge body.
Slide the hinge pin into the hinge body.
i
Insert the retention clip through the hinge so that the retention clip is
j
below the spring.
4 Reverse the bottom hinge body.
Remove the Allen bolt that secures the hinge body to the rack, and
a
place the bolt in a safe location.
Rotate the hinge body 180 degrees so that the hinge posts are now on
b
the right side of the hinge body (see Figure 1-6).
Locate the bottom bolt hole in the right side of the rack, and use the
c
Allen bolt to fasten the hinge body to the right side of the rack.
5 Rotate the front door 180 degrees so that its hinge-pin housings are on the
right side (see Figure 1-7).
Dell™ PowerEdge™ 4210 Installation Guide
17