Download  Print this page

Removing The Door Panels From The Optional Door Kit; Coupling Two Racks - Dell PowerEdge 2410 Installation Manual

Document.
Hide thumbs

Advertisement

Removing the Door Panels From the Optional Door Kit

If you purchase the optional door kit, do the following to remove the door
panels:
1 Install the doors according to instructions provided in the door kit.
2 Open the rack doors and locate the panel at the top of each door.
3 One panel at a time, loosen captive screws on the bottom of the panel.
4 Grab the sides of the panel and pull up to unseat them from the door.
5 Repeat steps 3 and 4 on the other door panel.

Coupling Two Racks

CAUTION:
couple two rack cabinets by yourself.
1 Unpack and set up both racks.
2 Unpack the coupling kit, shown in Figure 1-13.
The contents of the rack coupling kit include:
Four gasket strips
Four hexagonal spacers
Eight Allen screws
A stamped-metal crescent wrench
A T-handle Allen wrench
26
Dell™ PowerEdge™ 4210 Installation Guide
Because of the size and weight of the rack cabinets, never attempt to

Advertisement

Chapters

Table of Contents

   Related Manuals for Dell PowerEdge 2410

Comments to this Manuals

Symbols: 0
Latest comments: