Dell PowerEdge 2410 Manual page 7

Cabling the Dell™ PowerEdge™ R610
4. Once all the cables are routed through the CMA, dress the cables between the back of the system and the
entrance of the CMA with the tie wraps provided in the CMA kit. The tie wraps are shown in yellow in all
illustrations.
5. Clip off the excess length of material from the tie wraps and make sure that the tie wraps are positioned to
avoid interference with adjacent systems.
6. Return the CMA to the closed (retracted) position.
7. Extend the system from the rack to verify there is sufficient slack in the cables at both the entrance and exit of
the CMA.
8. See Figure 5 for an example of a completed left side mounted CMA installation.
Figure 5: Completed Left Side Mounted CMA Installation
Right Side Mounting Instructions
Install the CMA on the right rear side of the rails by attaching both CMA housings to the attachment brackets on
the rails. Follow steps 2‐7 from the right side mounting instructions in the previous section. See Figure 6 for an
example of a completed right side mounted CMA installation.
Figure 6: Completed Right Side Mounted CMA Installation
Page 5