IBM 86495BX Installer And User Manual page 43

3. Select the order within the list where you want to add a server. If no
servers have been added to the scan list, your cursor will appear in a
blank line at the top of the dialog box.
-or-
To add a server to the end of the list, place your cursor in the last server
entry and press the Down Arrow key.
-or-
To add a server in the the midst of an existing list, place your cursor in the
line below where you want to insert a new server and press Insert.
4. Type the fi rst few characters of a server name or port number to scan. The
fi rst matching server will appear in the line.
-or-
To move through the server list, press the following keyboard commands
in the Name, Port or Sec column to move through the list of servers
available to scan.
a. Press Alt+Down Arrow to move the cursor down through the list of servers.
b. Press Alt+Up Arrow to move the cursor up through the list of servers.
c. Press Alt+Home to move the cursor to the fi rst server in the list.
d. Press Alt+End to move the cursor to the last server in the list.
5. In the Sec column, type the number of seconds (from 3 to 255) of desired
delay time before the scan moves to the next server in the sequence.
6. Move the cursor to the next line or press the Down Arrow and repeat steps
2-5 for each of the remaining servers to be included in the scan pattern.
7. Click OK.
To remove a server from the scan list:
1. In the Scan dialog box, click the server to be removed.
2. Press Delete.
-or-
Press Shift+Delete to remove the selected server and all entries below it.
3. Click OK.
To start the scan mode:
1. Press Print Screen. The Main dialog box will appear.
2. Click Commands. The Commands dialog box appears.
Chapter 3: Basic Operations
35