Table of Contents
Advertisement
10
LCM Installer and User Guide
Statement 4:
DANGER
Electrical current from power, telephone, and communication cables is
hazardous.
To avoid a shock hazard:
•
Do not connect or disconnect any cables or perform installation,
maintenance, or reconfiguration of this product during an electrical
storm.
•
Connect all power cords to a properly wired and grounded electrical
outlet.
•
Connect to properly wired outlets any equipment that will be attached
to this product.
•
When possible, use one hand only to connect or disconnect signal
cables.
•
Never turn on any equipment when there is evidence of fire, water, or
structural damage.
•
Disconnect the attached power cords, telecommunications systems,
networks, and modems before you open the device covers, unless
instructed otherwise in the installation and configuration procedures.
•
Connect and disconnect cables as described in the following table
when installing, moving, or opening covers on this product or
attached devices.
To Connect:
1.
Turn everything OFF.
2.
First, attach all cables to devices.
3.
Attach signal cables to connectors.
4.
Attach power cords to outlet.
5.
Turn device ON.
Vertical installation in the side of a rack cabinet
1.
Line up the small holes of the kit's L-shaped brackets with the screw
holes in the switch.
2.
With a Phillips screwdriver, fasten the mounting brackets to the switch
using two 8/32" x 1/2" pan head screws on each side.
3.
Mount the switch assembly to the rack by matching the long slots on each
bracket to an appropriate set of holes on your equipment rack. Next, insert a
combination hex head screw through the slots in the bracket and the holes in
the side brace. Cap the screw with a hex serrated fl ange nut and tighten.
To Disconnect:
1.
Turn everything OFF.
2.
First, remove power cords from outlet.
3.
Remove signal cables from connectors.
4.
Remove all cables from devices.
Hide quick links:
Advertisement
Table of Contents
