Panasonic WV-CW504SE Installation Manual page 9

[Precautions for use]
This product has no power switch.
Turn the power off when cleaning the product.
To keep on using with stable performance
Parts of this product may deteriorate and it
may shorten the lifetime of this product when
using in locations subject to high temperatures
and high humidity. (Recommended operating
temperature: +35 °C or lower)
Do not expose this product to direct heat
sources such as a heater.
Handle this product with care.
Do not abuse this product. Avoid striking,
shaking, etc. The product could be damaged
by improper handling or storage. If a strong
shock or vibration is applied to the enclosure, it
may cause damage or allow water to enter this
product.
Do not touch the dome cover with your
bare hands.
A dirty dome cover causes deterioration of pic-
ture quality.
Discoloration on the CCD color filter
When continuously shooting a bright light
source such as a spotlight, the color filter of
the CCD may have deteriorated and it may
cause discoloration. Even when changing the
fixed shooting direction after continuously
shooting a spotlight for a certain period, the
discoloration may remain.
Do not aim this product at strong light
sources.
A light source such as a spot light causes a
blooming (light bleeding) or a smear (vertical
lines).
Smear
Blooming
Blight subject
Cleaning this product body
Turn the power off when cleaning the product.
Do not use strong abrasive detergent when
cleaning this product. Otherwise, it may cause
discoloration. When using a chemical cloth for
cleaning, read the caution provided with the
chemical cloth product.
To remove stubborn stains
When the dirt is hard to remove, use a mild
detergent and wipe gently. Then, wipe off the
remaining detergent with a dry cloth.
What to do if OVER HEAT appears on the
display
This message indicates that the inside of the
camera has become extremely hot. Immediate-
ly turn off the power of the camera and contact
your dealer.
About the dehumidifying device
• This product has dehumidifying device to
keep the inside at low moisture level, pre-
venting condensation.
• Dew may be produced depending on the
conditions of temperature, humidity, winds,
and rain, and it may take time to dehumidi-
fy.
• Never seal the surfaces of the dehumidify-
ing device.
Dehumidifying device
9