Optimize Your Remote Controls; Change The Address - Dish Network DISH 625 Description And Installation Manual

Optimize Your Remote Controls

Change the Address

When you receive your system, both remote controls and the receiver have been
set to communicate on address 1. However, because UHF signals travel long
distances and go through walls, a neighbor's UHF Pro remote could control
your receiver by mistake if they are on the same address.
: You can also use this procedure to change the
Note
for IR Remote Control 1 on a nearby TV, if necessary. However, if you are using
a UHF Pro remote to control
address.
To handle this situation, you can change address on Remote Control 2 and the
receiver as follows:
1. Make sure you turn on the TV.
2. Press the front panel SYSTEM INFO button to display the
screen.
The
System Info
Write down this address:
3. Press and hold the SAT button on Remote Control 2 for about
three seconds, until all of the mode buttons light up, and then let
go of the SAT button.
4. Use the NUMBER PAD buttons to enter any number between 1 and 16, but
not the one you wrote in step 2.
Write down the number you entered:
5. Press the POUND (#) button. If you entered the address correctly,
the SAT mode button will flash three times.
, use the instructions on page 46 to change the
TV1
screen shows the
Secondary Remote Address
Optimize Your Remote Controls
Primary Remote Address
System Info
.
Page 43