Get The Script That The Wizard In The Video Server Has Created - Axis 2400 - PHP3 GUIDE Manual

3.3.2.1 Get the script that the wizard in the Video Server has created

Start by going through the wizards in the Video Server, then open an FTP session to
the Video Server. Follow the instructions below to see how this can be accomplished:
Open a DOS session and type the following commands:
1. Go to the path where the script is saved
Eg: c:\axis\php
2. ftp <ip-address to the camera>
Eg: ftp 10.13.9.73
3. Type the user name
Eg: user name: root
4. Type the password
Eg: password: pass
5. Type: bin
6. Type: hash
7. Type: cd etc
At startup, utask reads the file /etc/task.list and parses it for event entries.
Therefore, it must be fetched to be able to run the script in an automatic fashion.
(See also section 3.3.3 The task-Scheduler.)
8. Type: get task.list
9. Type: cd php
10. Type ls to see the file names for the files that the wizard has created:
Ex: ls
11. Type: get <the script that is to be changed>
Axis Communications AB does not provide support for application development of any kind. The
information here is provided "as is", and there is no guarantee that any of the examples shown
will work in your particular application.
Revision 0.91 June 2001
PHP3 Guide
10