Clifford MATRIX 1X Manual page 50

To arm using your LCD remote
You can activate, or arm, the system by pressing
➤
second. When the system arms, you will hear a short siren sound, or chirp, and the
parking lights will flash once. If the vehicle's power door locks have been connected
to the system, the doors will lock.
To disarm using your LCD remote
To disarm the system, press
➤
will flash twice. If power locks are connected to the system, the doors will unlock.
If the siren chirps either four or five times when disarming, see Diagnostics section.
This is called Tamper Alert.
Arming while driving
Press on your remote for two second while the vehicle is running. The system
➤
will chirp once and then once more to indicate that the ignition is on.
Disarming without a LCD remote
Turn on the ignition. Press and release the Valet
➤
of times within 15 seconds. After five seconds, the system will disarm. If it does
not, you may have waited too long. Turn the ignition off and on and try again.
To enter or exit Valet
Turn ignition to RUN position, then turn to OFF position. Press and release the
➤
Valet button within 10 seconds. The in-vehicle status LED will light solid if you
®
are entering Valet
To activate Panic Mode
Press and hold
➤
To exit Panic Mode
Press or
➤
To activate Silent Mode™
Press briefly before arming or disarming, and the confirmation chirp(s) will
➤
be eliminated for that one operation only.
Location of Valet
Number of Valet
© 2008 directed electronics
QUICK REFERENCE GUIDE
. You will hear two chirps, and the parking lights
® Mode
® Mode, and it will go out if you are exiting Valet
or down for approximately two seconds.
on the remote.
® Button_______________________________
® Button pulses for disarming_____________
on your remote for one
button the programmed number
®
® Mode.
45