Illumination On/Off; Page Notification; To Exit Programming Mode - Clifford MATRIX 1X Manual

➜

Illumination On/Off

Press to select LCD backlight illumination On/Off. The
LCD backlight will illuminate when a remote button is pressed,
or an alarm status page is received.
L L C C D D B B a a c c k k l l i i g g h h t t s s e e t t t t i i n n g g s s P P r r o o g g r r a a m m m m i i n n g g r r e e s s p p o o n n s s e e
ON
OFF
➜

Page notification

The remote control can be programmed to notify the user of a
page (audibly beeping if the vehicle's status changes, e.g. door
unlocked, engine started, vehicle violation, etc.). On the LCD
remote press
Two beeps is page Off. When programmed off the remote will not
give any notification that a page was received from the vehicle.
N N o o t t e e : : If programmed Off, n n o o a a l l a a r r m m s s will be notified to the
remote. Command information (armed/disarmed) will be noti-
fied to the remote.
➜

To exit programming mode

The LCD remote control will exit programming mode after 5-
seconds of inactivity and will emit 2 long beep.
© 2008 directed electronics
1-beep, backlight ON
2-beeps, backlight OFF
to select page On/Off. One beep is page On,
15