Disarm/Valet Mode - Clifford AvantGuard 5.1 Owner's Manual

disarm/valet mode

Entering your pin code using the PlainView 2 Valet switch allows you
to disarm the system or enter valet mode without using the transmit-
ter. In valet mode, the security system will not arm, even with the trans-
mitter, but all convenience functions (door locks, trunk release, etc.)
will continue to work normally.
To disarm or enter Valet Mode:
The LED status indicator will light steadily when Valet Mode has been
entered.
To exit Valet Mode:
14
1. Turn the ignition on.
2. Enter PIN code (factory setting is 2 - this
procedure is described later in this manual).
3. After the last digit of the pin code is entered:
a. To disarm the system: press and release
b. To enter valet mode: Press and hold
three seconds.
1. Turn the ignition on.
2. Enter PIN code.
3. After the last digit press
The LED status indicator will turn off when
Valet Mode has been exited.
.
for
for one second.