Disarming; Disarming Without A Transmitter8; Remote Siren Silencing - Clifford CONCEPT 470 Manual

disarming

To disarm the system, press . You will hear a chirp and the park-
ing lights will flash once. If the power locks are connected to the sys-
tem, the doors will unlock. If the siren chirps three times when disarm-
ing, refer to the Diagnostics section of this guide. This is called Tamper
Alert. If the siren is active when the system is disarmed you will hear
two chirps but the system is not disarmed. (Refer to the Remote Siren
Silencing section of this guide.) However, if the alarm completes the full
trigger cycle when disarmed you will hear three chirps.
disarming without a transmitter
This feature allows you to disarm the system without the transmitter
should it be lost, damaged, or disabled. In order to disarm without a
transmitter, you must have the vehicle's ignition key, know where the
PlainView 2 Valet switch is located, and have the PIN code. Be sure to
check with the installer for the location of the PlainView 2 Valet switch.
Please refer to the Disarm/Valet Mode section of this guide for instruc-
tions to enter the pin code.

remote siren silencing

This system offers remote siren silencing. Remote siren silencing is a fea-
ture that makes it possible to silence and reset the system when it is
triggering without disarming the system. If the system is triggered and
the siren has been sounding, press on the transmitter to stop the
trigger and return the unit to the armed state. The system will not dis-
arm, but rather reset. This prevents you from disabling the system
should you wish to silence it without visually checking the vehicle. After
8