System Override - Clifford 3.3X Owner's Manual

If you hear five chirps on disarming, the system was repeatedly
triggered in your absence. Immediately look at the Status LED in the
vehicle and count the number of flashes between pauses. This number
is important, it tells what triggered your alarm.
The door locks (if connected) will unlock, and the parking lights will
flash.
While the alarm is triggering:
▀
Press the
and disarm the alarm system.
High-Security Disarming
If you want the Full Alarm response to stop without unlocking the
X
A U
doors, press the
alarm response will reset.

System override

To disarm the system without a remote control:
You will need to use your Override Switch located on your systems
control center (see diagram below) to disarm the system. The Override
Switch disarms the system only if you have the vehicle key.
To check proper operation:
▀
Open the door. The alarm will sound.
Immediately insert the key into the ignition and turn it to the RUN or
ON position. (all the indicators in the dash will turn on).
▀
Press the Override Switch once.
Note: The Override Switch feature allows you to select a specific
number of presses needed to disarm the alarm. If the Override

button on the remote. The siren will stop sounding
button. The system will re-arm and the current
2
3
4
5
6
© 2008 Directed Electronics—all rights reserved