Clifford 3.3X Owner's Manual page 20

adjust mode:
▀
Press/hold the
until the Amber LED turns on and you hear one long beep.
▀
Press/hold the
once:
The control module will emit one long chirp, enter adjust mode, and
send the current level of information back to the transmitter. The
remote will beep once and the button LEDs will turn on to indicate the
current level.
Press the Arm, Disarm, or Remote Start buttons to adjust the sensor
level.
1
Arm button: Pressing the
level. The siren chirps twice, the remote beeps twice and the LEDs
increase in level.
Disarm button: Pressing the
one level. The siren chirps once, the remote beeps once and the LEDs
decrease in level.
Remote Start button: Pressing the
level 7. The siren chirp three times, the remote beeps three times and
the LEDs reset.
To exit the adjust shock sensor mode from the remote control:
▀
Press the
To exit the adjust shock sensor mode from the control module:
▀
Open an entry point or turn on the ignition, the control module will
emit one long chirp and tell the remote to exit adjust mode.
To exit programming:

button of the remote control for 8 seconds or
button 1.5 seconds or until the amber led flashes
button will increase the sensitivity one
button. The control module is exited.
button will decrease the sensitivity
button will reset to default
A U X
© 2008 Directed Electronics—all rights reserved
2
3
4
5
6