Configuring The Ip Address Of The Pc - TRENDnet TV-IP252P - SecurView PoE Dome Internet Camera Network User Manual

3.3 Configuring the IP Address of the PC

If you have failed to access the camera, please check the IP
address of your computer. When you connect the camera to your
computer directly, proceed with configuration of the camera. You
need to set up the IP addresses to be in the same segment for
the two devices to communicate.
1. On your computer, click Start > Control Panel to open the
Control Panel window.
2. Double-click Network Connection to open the Network
Connection window.
3. Right-click Local Area Connection and then click
Properties from the shortcut menu.
4. When the Local Area Connection Properties window
appears, select the General tab.
5. Select Internet Protocol [TCP/IP] and then click
Properties to bring up the Internet Protocol [TCP/IP]
Properties window.
6. To configure a fixed IP address that is within the segment
of the camera, select the Use the following IP address
option. Then, enter an IP address into the empty field. The
suggested IP address is
30), and the suggested Subnet mask is 255.255.255.0.
7. When you are finished, click OK.
192.168.10.x (x
- 26 -
is 1~254 except