Sony RM-AX4000 - Integrated Remote Commander Software Manual page 14

The "Component Settings - Programming the Preset Codes of Components (SOLUTION)" screen reappears, and the second component setting starts.
Repeat steps 5 to 13 to finish all the component settings.
Hint
If only one component is added in step 1, the "Component Settings - Programming the Preset Codes of Components (SOLUTION)" screen does not
appear. In this case, go to step 15.
15. Click "Ne xt."
A dialog box appears asking if you are sure you w ant to save the settings and continue.
16. Click "Ye s ."
The "XPRESS Settings - What is XPRESS?" screen appears.
Follow ing the w izard instructions,
About the component category
When you select the component category (type) in the "New Project" w izard (for creating a project) or in the "New Component" w izard (for adding a
component), be careful of the follow ing:
A "DVD/Receiver Combo" is a Sony AV amplifier w ith a built-in DVD player.

 A "DVR/DVD Combo" is a DVD recorder w ith a built-in hard disk drive.
 Except the DVD/Receiver combo, the components w ith the built-in amplifier should be registered as Receiver. All the keys that are inoperative should be
registered by the learning function.
 When you have a multi-component (such as a DVD/VCR combo), select only one of either component for the category.
For example, in the case of a DVD/VCR combo, select "DVD" or "VCR" for the category. If you select both components, the
properly.
Only w hen you add a component in Advanced mode, can you select "None" (that has no preset code). When you cannot find an appropriate component

type, select "None."
set XPRESS keys.
XPRESS function w ill not w ork
Page 14