Reinstallation Of The Doors; Door Reversal; Fresh Food Handles - Maytag MBF2256KEB - Bottom Freezer Refridgerator Installation Instructions Manual

Installation

Reinstallation of the Doors

Materials Needed:
• Phillips screwdriver
• 5 " hex head driver
⁄
16
1. Install hinge assemblies:
• Install top hinge loosely with
• Install center hinge with Phillips screws.
• Freezer door models: Install bottom hinge with
" hex head screws.
3
⁄
8
2. Freezer door models: Insert bottom hinge pin.
• Locate bottom hinge hole closest to
outside edge of cabinet, and insert
bottom hinge pin. Replace any door
shims, if present.
3. Freezer door models: Place hinge
side of freezer door on bottom hinge
pin and hold freezer door upright
while installing center hinge pin with
5 " hex head driver.
⁄
16
• Replace plastic sleeve.
• Replace any applicable door shims.
• Make sure the hinge pin is installed tightly.
4. Place hinge side of refrigerator door on center hinge
pin.
5. While holding refrigerator door
upright, tighten down top hinge
with 5 " hex head driver and
⁄
16
replace hinge cover.

Door Reversal

In some installations, reversing the door swing allows
for more convenient access to stored items. Both doors
can be reversed on freezer door models and the fresh
food door is reversible on freezer drawer models.
Materials Needed:
• Flat screwdriver
• Phillips screwdriver
• 5 " hex head driver
⁄
16
• 3 " hex head driver
⁄
8
1. Remove door(s) (see page 4).
2. Transfer cabinet plugs and cabinet
screws to opposite side of cabinet.
• Remove cabinet plugs with flat
blade of screwdriver tip wrapped in masking tape.
5 " hex head screws.
⁄
16
• Remove center mullion screws with
screwdriver.
• Freezer door models: Remove bottom mullion
screws with 3 " hex head driver.
⁄
8
CAUTION
To avoid possible injury and damage to property:
• Place doors on a nonabrasive surface protected by
towels or rugs while working directly on doors.
3. Transfer door stops from bottom edge of fresh food
door and freezer door, if applicable, to opposite
side of door edge.
• Use a Phillips screwdriver
for removal and installation.
4. Install handles (see pages
6-8).
5. Reinstall the door(s).
Handles
Note:
If not installed, the handle is located in the
interior of the fresh food compartment or attached
to the back of your refrigerator.
Remove and discard handle packaging and tape.
Handle design varies from refrigerator to refrigerator.
Please reference the appropriate instructions for your
model below.

Fresh Food Handles

Standard Front Mount Handle
Materials Needed:
• Phillips screwdriver
• 5 " hex head driver
⁄
16
To Install:
1. Remove 1 " hex head screws from
⁄
4
door face with hex head driver, and
Phillips screw from top of door.
• If reversing door, remove door plugs
from opposite side of door and insert
in screw holes.
2. Align handle holes with screw holes on
door face and secure with two door face
screws from step 1.
5 " hex head
⁄
16
Cont.
6