Maytag MBF2562HEB Installation Instructions Manual

Your refrigerator was packed carefully for shipment.
Remove and discard shelf packaging and tape. Do not
remove the serial plate.
Do not install refrigerator near oven, radiator or other
heat source. Wf n ot possible, shield refrigerator with
cabinet material.
Do not install where temperature falls below 55 ° F
(13° C} or rises above 110° F (43 ° C}. Malfunction
may occur at this temperature.
Refrigerator is designed for indoor household
application onlyo
Measuring the Opening
When installing your refrigerator, measure carefully.
Allow Y2 space at top and '/2"space behind the
machine compartment cover (located in the rea0 for
proper air circulation.
Subfiooring or floor coverings (i.e. carpet, tile, wood
floors, rugs} may make your opening smaller than
anticipate&
Some clearance may be gained by using the leveling
procedure under Leveling.
UMPORTANT: If refrigerator is to be installed into a
recess where the top of the refrigerator is completely
covered, use dimensions from floor to top of hinge cap
to verify proper clearance.
Transporting Your Refrigerator
NEVER transport refrigerator on its side. If an
upright position is not possible, lay refrigerator on its
back. Allow refrigerator to sit upright for
approximately 30 minutes before plugging it in to
assure oil returns to the compresson Plugging the
refrigerator in immediately may cause damage to
internal parts.
Use an appliance dolly when moving refrigerator.
ALWAYS truck refrigerator from its side or
back-NEVER from its front.
Protect outside finish of refrigerator during transport
by wrapping cabinet in blankets or inserting padding
between the refrigerator and dolly.
Secure refrigerator to dolly firmly with straps or
bungee cords. Thread straps through handles when
possible. Do not overtighten. Overtightening
restraints may dent or damage outside finish.
To enhance the appearance and maintain performance
the refrigerator should be level
Note
Complete any required door reversal, panel
installation and/or a water supply connection,
before leveling.
Materials Needed:
3/8"hex head driver
Carpenter's level
1. Remove toe grille.
Grasp firmly and pull outward
to unclip.
2. Remove bottom bracket cover(s}.
Place the eraser end of a pencil or similar blunt
tool in the cover notch.
, Use slight pressure to pry the
cover loose.
Continue to maintain
downward pressure to the
notched side of the cover while
swinging it oft