Advertisement
Reversing The Door Swing
Should you wish to reverse the direction in which the door opens (i.e.; from left to right
or right to left) please follow the instructions detailed below. Never attempt to reverse the
door opening by turning the door upside down. The existing / new hinges (depending on
model) must always be moved to the opposite side of the door as shown above. The door
should always remain the correct way up.
Slacken the retaining screws (1) on the appliance
Remove the appliance door
Lever off the cover caps (3) with a knife blade
Insert retaining screws (1) on the opposite side as shown above (screw in so as to
secure but do not tighten)
Remove the door retaining screws (2) and relocate the hinges as shown above
Locate the door in the previously inserted screws and tighten
Insert cover caps (3) into the exposed holes where the hinges were previously
located.
Please note: When reversing the door of the appliance, the door seal on the side of the
existing hinges may have become compressed over time. If this is the case, the seal may
not make good contact with the cabinet when the door is closed. To revert the seal back
to its original form, simply heat the seal with a hairdryer for no more than 1 minute.
Always ensure the hairdryer is at least 20cm away from the door seal and allow the seal
to cool for a minimum of 2 minutes before closing the door.
Advertisement
