Overview; Serial Interface Specification; Transfer Specification; Connection - Sanyo PDG-DSU30 - 2500 Specifications

PDG-DSU30 Basic Serial Command Specifications
1

Overview

1.1.
This specification defines projector control commands for the PDG-DSU30 series.
1.2.
The projector control commands are designed to remote-control a projector through RS-232C
from a computer.
2

Serial Interface Specification

2.1

Transfer Specification

Items
Synchronous system
Transmission Speed
Data Length
Parity
Stop Bit
Flow Control
2.1.1. Transmission speed: The initial setting value is 9600.
2.2

Connection

Dedicated serial cable that meets to following specifications must be used for the connection to
a computer and the projector.
Connect COM port of the computer to SERIAL PORT IN of the projector.
COM Port (COM1 or COM2) of a computer is specified by the control software of the computer.
Asynchronous
9600
8 bits
None
1
None
PC
COM 1{ I
3Pin Cable of Dsub
Pin No Name Connect Pin No
1 TX D
2 RX D
3 GND
shielding shielding
4/17
Specification
Projector
Control Port
9Pin Cable of Dsub
Name
2 RX D
3 TX D
5 GND
shielding shielding