Step 7; Step 8 - Directed Electronics G322R Owner's Installation Manual

step 7

Dome light supervision (optional)
The dome light wire is optional and not required for normal
operation, however if desired you can have the security system
turn on the dome light when the system is disarmed. If you
would like this feature please refer to the web site or call tech-
nical support.

step 8

Siren connection
The siren should be located under the hood of the vehicle and
clear of any moving parts and anything that generates an
extreme amount of heat, find a location that will accommodate
these requirements and with a couple of self tapping screws
mount the siren facing downward. With the siren securely
mounted cover the first 12 inches of the siren wire with electrical
tape, Locate a rubber grommet that you can gain access to and
with a sharp object poke a hole through the grommet, using
electrical tape attach the end of the siren wire to the sharp object
and poke it back through the existing hole, from the inside of
the vehicle pull the remaining slack of the siren wire into the car
and remove the sharp object. Route the wire to the desired posi-
tion making sure to keep it away from all moving parts. Now
solder the Red wire of the siren to the BROWN (H1/10) wire
on the 12 pin main harness, cover the connection with electrical
tape. Ground the Black siren wire to the same location as the
BLACK (H1/8) wire of the 12 pin main harness.
16 © 2003 directed electronics, inc.