Step 6 - Directed Electronics G322R Owner's Installation Manual

i i m m p p o o r r t t a a n n t t : : While reading the meter turn (adjust) the
dash dimmer control switch. The voltage should not vary
on the meter. If the voltage does vary the incorrect sus-
pected wire has been tested. Find the correct wire and
retest.
Once you have identified the correct wire, solder the WHITE
wire on the main connector to it and cover the connection with
electrical tape.

step 6

Door triggers
The door trigger is the circuit in the vehicle that tells the dome
light to come on when the door is opened. This wire can be
either a positive 12 volt polarity or more commonly a negative
ground polarity, the door trigger wire is mandatory for all secu-
rity systems
www.diyrattler.com. Using the information sheet for your
specific vehicle locate the suspect wire, if the door trigger listed
for your car is a negative type door trigger place the red lead of
your meter to a constant 12 volt source and secure it, take the
14
and can usually be identified on
© 2003 directed electronics, inc.