Step 1 - Directed Electronics G312R Owner's Installation Manual

step 1

Plug-in LED and Valet/Program switch
The LED and the Valet®/Program switch both plug into the
control module. The status LED plugs into the white two-pin
port, while the Valet®/Program switch should be plugged into
the blue two-pin port. The status LED and Valet®/Program
switch each fit into 9 / 32 –inch holes.
S S t t a a t t u u s s L L E E D D
note: The security features consist only of ignition watch
where the horn will honk if the keyless system sees igni-
tion when locked and the security feature is turned on in
the features learned routine.
When mounting the LED it will be necessary to locate an area on
the dash that is visible from all sides of the vehicle, and has at
least 1 inch of clearance behind the mounting area. It is recom-
mended that a factory "pop-out" be used for the LED mounting,
using a 9/32 drill bit drill a hole in the location selected, feed the
LED through the hole, press the LED firmly until it snaps into
place. Run the wires to the selected control module mounting
8
V V a a l l e e t t / / P P r r o o g g r r a a m m S S w w i i t t c c h h
© 2003 directed electronics, inc.