Battery Replacement; Technical Specification - Marshall Amplification EFFECT PEDAL ED1 COMPRESSOR Owner's Manual

Battery Replacement

1. To replace the battery, open
the easily accessed coin
screw battery cover plate by
loosening screw as shown,
then disconnect the battery
connector lead.
2. Use PP3 or equivalent
battery (for improved
battery life use alkaline
type)
3. Always ensure that the
battery is removed when the
pedal is not in use for long
periods.
4. Dispose of old battery
in a safe place.

Technical Specification

Power: 9V DC Centre Negative Regulated
Current Draw: 5mA
Controls: Emphasis Mode Select, Volume, Attack,
Compression
Switches: On/Off Switch
Indicators: On/Off LED
Jacks: Input/Output 'Jacksockets'
Input Impedance: > 1MΩ
Output Load Impedance: < 20kΩ
Dimensions: 120mm x 65mm x 55mm
Weight: 510 grammes
6