Chapter 2: Installation; Before You Begin - Visioneer STROBE 500 - FOR WINDOWS User Manual

Installation
Installation is a quick, three-step process:
1. Unpack and Assemble the scanner
2. Install the software and Connect the scanner
3. Register the scanner
B Y B
EFORE OU EGIN
Please make sure of the following before you begin installation:
Do not plug in the USB cable until after you install the software.
■
Complete the installation steps in the order described in this guide.
■ If you are prompted to reboot the computer during installation, please
select the option to restart the computer later. Finish installing the rest of
the software, then close all open windows and reboot the computer.
■ If your computer has AntiVirus or AntiSpyware software running, you
may see messages during installation asking you to allow the installation
to proceed. The messages will differ based on the software your
computer is running, but in each case allow the installation to proceed.
Alternatively, you can turn off the AntiVirus or AntiSpyware software
before installing your scanner. But if you do, make sure to turn it back
on again when installation is finished.
If you already have a scanner connected to your computer, you may need
■
to remove its driver programs first before beginning the installation of
your Visioneer Strobe 500 scanner. Please see the User's Guide that you
received with your other scanner for specific instructions.
B Y B
EFORE OU EGIN
5