Panic Mode; Code Hopping - Directed Electronics 411R Series Owner's Manual

Auto-security device

Table of Contents

Panic Mode

If you are threatened in or near your vehicle, you can attract

attention by triggering the system with your remote! Just press

and hold

for 1.5 seconds, and you will enter Panic Mode. The

horn will honk and the parking lights will flash for 30 seconds. To

stop Panic Mode at any time, press

NOTE: In order for Panic Mode to function, the vehicle's horn (or option-

al siren) must be connected.

The receiver and transmitter use mathematical formulas called

algorithms to change their codes each time the transmitter is used.

This Code Hopping technology has been developed to increase the

security of the unit. By following this set code sequence, the

receiver and transmitter stay synchronized, even if the transmitter

is used out of range of the vehicle. If, however, the transmitter is

pressed many times out of range, or the battery is removed, the

transmitter may get temporarily out of sync and fail to operate the

system. To resynchronize the transmitter, simply press

times within range of the vehicle. The system will automatically

resynchronize and the transmitter will respond normally.

2000 Directed Electronics, Inc.

on the remote.

™

several

Table of Contents