Canon 3433B010 Basic Manual page 48

Error Messages
Error Message
Cannot detect papr
Rel lever is in wrong position.
Roll printing is selected.
Roll printing is selected, but
sheets are loaded.
Cause
The paper has come out of the
printer.
The Release Lever is pushed
back.
You have attempted to print a test
print sheet or other printer status
information on a roll, but no roll is
loaded.
A print job for rolls was received
when a sheet is loaded.
48
Corrective Action
Follow these step to reload a sheet.
1. Remove the paper and press the OK button.
2. Reload the sheet, aligning it with the guide on the
right.
(→ , Loading Sheets in the Printer)
Follow these step to reload a sheet.
1. Push the Release Lever back and remove the
paper.
2. Pull the Release Lever forward.
3. Reload the sheet, aligning it with the guide on the
right.
(→ , Loading Sheets in the Printer)
Pull the Release Lever forward.
Turn off the printer and wait a while before restoring
power.
Press ▲ or ▼ to select Load Roll Paper , and then
press the OK button. Load the roll, and then print.
(→ , Attaching the Roll Holder to Rolls)
(→ , Loading Rolls in the Printer)
To print on sheets, follow these steps.
1. Press ▲ or ▼ to select Stop Printing , and then
press the OK button to stop printing.
2. Load a sheet and try printing again.
(→"Loading and Printing on Sheets," User Manual)
Follow these steps to load and print on a roll.
1. Press ▲ or ▼ to select Eject Cut Sheet , press the
OK button, and remove the sheet.
(→ , Removing Sheets)
2. Load a new roll.
(→ , Loading Rolls in the Printer)
The printer now starts printing the print job.
Press ▲ or ▼ to select Stop Printing , and then press
the OK button.