Canon 3433B010 Basic Manual page 39

Error Message
Execute printhead cleaning.
Cannot adjust printhead.
Cause
The Printhead nozzles are
clogged.
The Printhead nozzles are
clogged.
The Printhead cannot be aligned;
highly transparent film is loaded.
The Printhead is installed crooked. Straighten the Printhead as follows, and then execute
39
Corrective Action
Follow these steps to clean the Printhead .
1. Stop printing by pressing ▲ or ▼ to select Stop
Printing .
2. Clean the Printhead .
(→ , If Printing is Faint)
If this message is still displayed, replace the
Printhead .
(→ , Replacing the Printhead)
Press ▲ or ▼ to select Print , and then press the OK
button to resume printing. However, note that this
error may affect the printing quality.
If OK is shown on the Display Screen , clean the
Printhead .
1. Press the OK button on the Control Panel to stop
printing.
2. Clean the Printhead .
(→ , If Printing is Faint)
If this message is still displayed, replace the
Printhead .
(→ , Replacing the Printhead)
Execute Head Posi. Adj. again, as follows.
1. Press the OK button to clear the error.
2. Print a test pattern to check the nozzles.
(→"Checking for Nozzle Clogging," User Manual)
3. Clean the Printhead if the nozzles are clogged.
(→ , If Printing is Faint)
4. Execute Head Posi. Adj. again.
(→ , If Vertical Lines are Warped or Colors are
Misaligned)
Press the OK button to clear the error.
We recommend using a type of paper that you often
use, other than film, for Printhead adjustment.
(→ , If Vertical Lines are Warped or Colors are
Misaligned)
Head Posi. Adj. again.
1. Press the OK button to clear the error.
2. Use Head Inc. Adj. to adjust the angle of inclination
of the Printhead .
(→"Adjusting Line Misalignment (Head Inc. Adj.),"
User Manual)
3. Execute Head Posi. Adj. again.
(→ , If Vertical Lines are Warped or Colors are
Misaligned)
Error Messages