Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Manual page 55

Copyright © 2010, Juniper Networks, Inc.
The attributes are as follows:
—(Required) Identifies the
application-id
the device. Each outbound-ssh
connection. This attribute is not sent to the client.
—(Required) Identifies the device to the client during the initiation
device-id
sequence.
secret secret —(Optional) Public SSH host key of the device running the Junos OS.
If this statement is added to the
running Junos OS will pass its public key to the configuration management server
during the initialization of the outbound SSH service. This is the recommended
method of maintaining a current copy of the router's public key on the configuration
management server.
—(Optional) Specify that keepalive messages be sent from the device
keep-alive
running Junos OS to the configuration management server. To configure the
keepalive message, you must set both the
—Number of keepalive messages the device running Junos OS sends
retry number
without receiving a response from the configuration management server before
the current SSH connection is terminated. The default is three tries.
timeout seconds —Amount of time, in seconds, that the server waits for data
before sending a keepalive signal. The default is 15 seconds.
reconnect-strategy (sticky | in-order)
Junos OS uses to reestablish a disconnected outbound SSH connection. Two
methods are available:
—The device attempts to reconnect to the configuration management
sticky
server to which it was last connected. If the connection is unavailable, the device
attempts to establish a connection with the next configuration management
server on the list and so forth until a connection is established.
in-order —The device attempts to establish an outbound SSH session based on
the configuration management server address list. The device attempts to
establish a session with the first server on the list. If this connection is not
available, the device attempts to establish a session with the next server, and
so on down the list until a connection is established.
When reconnecting to a client, the device running Junos OS attempts to reconnect
to the client based on the
the configuration management server list..
—(Required) Specifies the services available for the session. Currently,
services
NETCONF is the only service available.
—(Required) The host name or the IPv4 address of the configuration
address
management server. You can list multiple clients by adding each client's IP address
or host name along with the connection parameters listed below.
—Outbound SSH port for the client. The default is port 22.
port destination-port
Chapter 3: Controlling the Junos XML Management Protocol Session
outbound-ssh
stanza represents a single outbound SSH
configuration hierarchy, the device
outbound-ssh
timeout
—(Optional) Method that the device running
retry and timeout values for each of the clients listed in
configuration stanza on
and attributes.
retry
33