Mirror Cleaning - Dimplex Electric Fireplace Practical User's Manual

FIGURE 4
FIGURE 5
To access the light bulb area:
1. Open steel curtain (remove glass doors if
applicable).
2. Remove two screws on log grate and remove
log grate (FIGURE 4).
3. Pull rear edge of ember bed up and forward by
grasping ember bed by the sides (handle the
logset only by the emberbed and not the logs)
and pulling solidly until the rear tab pops out
from under the back ledge, then lift out.
(FIGURE 5)
4. Examine the bulbs to determine which bulbs
require replacement.
5. Unscrew bulbs counter clockwise.
6. Insert new bulbs.
7. Replace the log by inserting front edge and
pushing the back down until rear tab snaps
under back ledge (FIGURE 5) and the logs are
resting against mirror.
8. Replace log grate using two screws previously
removed.

Mirror Cleaning:

The mirror is cleaned in the factory during the
assembly operation. During shipment, installation,
handling, etc., the mirror surface may collect dust
particles; these can be removed by buffing lightly
with a clean dry cloth.
To remove fingerprints or other marks, the mirror
can be cleaned with a damp cloth using good
quality household glass cleaner. The mirror should
be completely dried with a lint free cloth or paper
towel.
CAUTION
Do not use abrasive cleaners on mirror
surface or spray liquids directly onto any
surface.
6