Mirror Replacement; Main On/Off Switch Replacement - Dimplex DF2608-AU Service Manual

! NOTE: Log set fits tightly into firebox, some force may be
necessary to remove.
6. Disconnect LED harness.
7. Set log set in front of fireplace.
8. Remove flicker rod by sliding flicker rod to the left away
from the flicker motor and lift out.
9. Remove light filter bracket (the metal bracket will have
a tinted film adhered to it) for easier access to light
bulbs. Four (4) Philips screws hold the bracket in place
(two (2) per side).
10. Unscrew bulbs counter clockwise.
11. Insert new bulbs.
12. Replace light filter bracket and flicker rod.
13. Re-connect LED harness.
14. Replace the log set by inserting the front edge of the
fireplace and push down on the rear edge of the
ember bed until it snaps into place.
15. Lay unit on it's back and slide front glass back into
position and attach trim.

Mirror Replacement

If the fireplace was operating prior to servicing allow at least
10 minutes for light bulbs and heating element to cool off to
avoid accidental burning of skin.
Disconnect power before attempting any maintenance or
cleaning to reduce the risk of electric shock or damage to
persons.
Replacement Procedure
1. Slide fireplace out of mantel.
2. Lay unit on it's back for safe removal of front glass.
3. Remove four (4) Phillips screws from the right side of
trim.
4. Slide glass to right side of fireplace to remove (Figure 5,
page 7).
CAUTION: Even though the glass is safety glass it may
break if bumped, struck of dropped. Care must be
taken when handling the glass.
5. Pull the front edge of the plastic ember bed or plastic
grate up and forward until the rear tab releases from
the ledge located at the bottom of the mirror.
! IMPORTANT: Only handle the log set by the ember bed.
! NOTE: Log set fits tightly into firebox, some force may be
necessary to remove.
6. Loosen but do not remove the two (2) Philips screws
that clamp the mirror in place, and swivel down so that
the clamp clears the edge of the mirror (Figure 6).
7. Push the mirror up from underneath to clear the frame
and remove.
8. Insert replacement mirror top end first and lay the
bottom end gently in the bottom track of the frame.
Figure 6
Clamp
9. Tighten clamps back into place and reassemble
fireplace in reverse order as described above.

Main On/Off Switch Replacement

If the fireplace was operating prior to servicing allow at least
10 minutes for light bulbs and heating element to cool off to
avoid accidental burning of skin.
Disconnect power before attempting any maintenance or
cleaning to reduce the risk of electric shock or damage to
persons.
Replacement Procedure:
1. Remove the firebox from the mantel.
2. Lay unit on its back.
3. Remove the 12 Philips screws that fasten the bottom
cover to the rest of the firebox. There are: two (2)
screws on each side; two (2) screws on the back panel
(you may have to tip the bottom of the fireplace up if it
is laying on its back), four (4) screws in the front directly
under the control panel; and two (2) screws on the
bottom of the fireplace (see Figure 7). The bottom panel
is now free to be removed.
Figure 7
Screws To Remove
4. Locate the Main On/Off Switch mounted on the control
panel on the left side (Figure 8, Page 9) and disconnect
the two (2) wiring clips noting their original locations.
8
Mirror