Advertisement
Lamp Replacement
To gain access to the lamps
1.
Remove the Front Cover by lifting up and out and carefully
leave to one side.
2.
Remove the two screws on the fuel effect.
3.
a) Lift one side of the fuel effect up first by holding the front
ledge,
b) and lift out gently, set aside carefully (taking care
not to damage the logs as they are fragile) – see Fig. 5.
4.
For access to the bulbs, carefully rotate the flexible
rotisserie out of position ensuring that the rubber grommet
is not lost – see Fig. 6.
5.
Unscrew the defective lamp anti-clockwise. Replace with
a 230V, 60W E14 SES lamp, do not over tighten (see
Fig. 6).
6.
Refit the fuel effect (with two screws) and Front Panel.
Thermal Safety Cut-out
For your safety, this appliance has been fitted with thermal cut-
out. In the event that the product overheats, the cut-out switches
the heat off automatically.
To bring the heat back into operation, remove the cause of the
overheating, then unplug or turn off the electrical supply to the
heater for up to 10 minutes.
When the heater has cooled sufficiently, re-connect and switch
on the heater.
Caution: In order to avoid a hazard due to inadvertent resetting of
the thermal cut-out, this appliance must not be supplied through
an external switching device, such as a timer, or connected to a
circuit that is regularly switched on and off by the utility.
The product complies with the Australian/New Zealand Safety Standards AS/NZ S 335.2.30:1997 and 2002 Part 1 also the European Standard ElectromagneticCompatibility (EMC) EN
55 014-1:1993, EN 61000-3-2:1995, EN 61000-3-3:1995, EN 55 014-2:1997 which cover the essential requirements of EEC Directive 89/336/EEC.
Specification subject to change without prior notice
Cleaning and Maintenance
Warning: Always disconnect from the power supply before
attempting any maintenance.
Cleaning
Before commencing cleaning, unplug the heater and allow it to
cool.
The surface of the heater should be given an occasional wipe
over with a soft damp cloth. Do not use detergents abrasive
cleaning powder or polish on the body of the heater. The glass
screen should be cleaned carefully with a chamois leather. Do
not use proprietary glass cleaners.
After Sales Service
Should you require after sales service, please get in touch with
the supplier through whom you purchased the appliance.
Please retain your receipt as proof of purchase.
Advertisement
