Dimplex EWMC-CC-SS Practical User's Manual page 3

REMOTE CONTROL USUAGE
The corner wall mounted electric fireplace is supplied with a radio frequency remote control.
This remote control has a range of approximately 50 feet (15.25m), it does not have to be
pointed at the fireplace and can pass through most obstacles (including walls). It is supplied
with one of 243 independent frequencies to prevent interference with other units. The
frequency designation is indicated on the back of the transmitter.
FIGURE 14
FIGURE 15
A. Remote Control Initialization
This procedure is required every time there is a loss
of power to the remote control in the fireplace.
(i.e. power failure, breaker tripped, main power switch
is turned off)
1. Ensure that power is supplied through main
2. Locate manual controls. (refer to FIGURE 13)
3. Activate main power switch, red indicator light 1
4. Press and hold the heater control switch for five
5. Press ON button located on the remote control
B. Remote Control Usage
The remote control operates the fireplace levels
sequentially. The level is increased every time the
ON button on the transmitter is pressed. The
fireplace can be turned off at any point by pressing
the OFF button on the remote control transmitter.
Manual
Selection
Level 1: The flame effect is turned on and the first red
Switch
indicator light is activated.
Main
Level 2: The flame effect remains on, the heater is
Power
activated to the low heat setting, and the first and
Switch
second red indicator lights are activated.
Level 3: The flame effect remains on, the heater is
set to the high heat setting, and all three red indicator
lights are activated.
Level 3 Indicator
Level 2 Indicator
Level 1 Indicator
service panel.
will flash.
seconds. The second red indictor light will flash.
transmitter (FIGURE 14). This will synchronize
the remote control transmitter and receiver.
9