Ipv6 Firewall - D-Link DIR-645 User Manual

Section 3 - Software Configuration
On this page the user can configure the IPv6 firewall settings. The firewall settings section is an advance feature that is used to allow or deny traffic
from passing through the device. It works in the same way as IP Filters with additional settings. You can create more detailed rules for the device.
In the IPv6 Firewall Rules section the user can create, enable and disable
IPv6 firewall rules used by this device. The following parameters will be
available for configuration:
Configure IPv6 This option defines the behavior of all the IPv6
Filtering: firewall rules created. Option to choose from are
'Turn IPv6 Filtering OFF' , 'Turn IPv6 Filtering ON
and ALLOW rules listed' , and 'Turn IPv6 Filtering
ON and DENY rules listed' . Select the appropriate
option used here.
Checkbox Tick this option to used the firewall rules created.
Name:
Enter a custom firewall rule name here. This name
is used for identification.
Source Interface: Select the appropriate source interface used here.
Destination Select the appropriate destination interface used
Interface: here.
Schedule: Select a time schedule that will be applied to this
rules here.
IP Address
Enter the IPv6 address range used here.
Range:
Protocol: Select the protocol used for this rule here. Options
to choose from are ALL, TCP, UDP, and ICMP.
Port Range: Enter the port range used for this rule here.
Click on the Save Settings button to accept the changes made.
Click on the Don't Save Settings button to discard the changes made.
D-Link DIR-645 User Manual

IPv6 Firewall

88