Ipv6 Firewall - D-Link DIR-816L User Manual

Section 3 - Configuration
The DIR-816L's IPv6 Firewall feature allows you to configure which kind of IPv6 traffic is allowed to pass through the device.
The IPv6 Firewall functions in a similar way to the IP Filters feature.
Enable IPv6 Check the box to enable the IPv6 firewall simple security.
Simple Security:
Configure IPv6 Select an action from the drop-down menu.
Filtering below:
Enter a Name to identify the IPv6 firewall rule.
Name:
Schedule: Use the drop-down menu to select the time schedule for enabling the
IPv6 Firewall Rule. The schedule may be set to Always, which will allow
this service to always be enabled. You can create your own schedule
in the Tools > Schedules section.
Source: Use the Interface drop-down menu to specify the interface that
connects to the source IPv6 addresses of the firewall rule.
Enter the source IPv6 address range in the adjacent IP Address Range
IP Address Range:
field.
Select the protocol of the firewall port (All, TCP, UDP, or ICMP).
Protocol:
Dest: Use the Interface drop-down menu to specify the interface that connects to the destination IP addresses of the firewall rule.
IP Address Range: Enter the destination IPv6 address range in the adjacent IP Address Range field.
Port Range: Enter the first port of the range that will be used for the firewall rule in the first box and enter the last port in the field in the second
box.
D-Link DIR-816L User Manual

IPv6 Firewall

105