D-Link DIR-645 User Manual page 56

Section 3 - Software Configuration
IPv6 Connection Type: Autoconfiguration (SLAAC/DHCPv6)
In the following section we'll discuss the parameters that can be configured when setting up an Autoconfiguration (SLAAC/DHCPv6) connection.
This is a method of connection where the ISP assigns your IPv6 address when your router requests one from the ISP's server. Some ISP's require you
to make some settings on your side before your router can connect to the IPv6 Internet.
The following parameters will be available for configuration:
Obtain IPv6
Select this option to obtain the DNS Server
DNS Servers
addresses automatically.
automatically:
Use the Select this option to manually enter the DNS
following IPv6 Server addresses used.
DNS Servers:
Primary DNS Enter the WAN primary DNS Server address used
Server: here.
Secondary DNS Enter the WAN secondary DNS Server address
Server: used here.
Select this option to enable DHCP PD.
Enable DHCP-PD:
Enter the LAN IPv6 address used here. This address
LAN IPv6 Address:
must be in the '/64' subnet.
LAN IPv6 Link-
Displays the LAN IPv6 Link-Local address used
Local Address:
here.
D-Link DIR-645 User Manual 52