D-Link DIR-645 User Manual page 50

Section 3 - Software Configuration
Manual IPv6 Internet Connection Option
For the advanced user that have configured a router before, click on
the Manual IPv6 Internet Connection Setup button to input all the
settings manually.
On this page the user can manually configure the mode that the
Router will use to access an IPv6 Internet connection. There are several
connection types to choose from: Link-local, Static IPv6, DHCPv6,
Stateless Auto-Configuration, PPPoE, IPv6 over IPv4 Tunnel and 6to4.
If you are unsure of your connection method, please contact your IPv6
ISP.
IPv6 Connection Type: Link-Local Only
The Link-local address is used by nodes and routers when communicating
with neighboring nodes on the same link. This mode enables IPv6-
capable devices to communicate with each other on the LAN side.
The following parameters will be available for configuration:
LAN IPv6 Link- Displays the LAN IPv6 Link-Local address used
Local Address: here.
Click on the Save Settings button to accept the changes made.
Click on the Don't Save Settings button to discard the changes made.
IPv6 Connection Type: Auto Detection
In the following section we'll discuss the parameters that can be
configured when setting up an Auto Detection (Stateless/DHCPv6)
connection. This is a method of connection where the ISP assigns your
IPv6 address when your router requests one from the ISP's server. Some
ISP's require you to make some settings on your side before your router
can connect to the IPv6 Internet.
D-Link DIR-645 User Manual 46