Kenmore 4803 - Elite 30 in. Wall Oven Installation Instructions Manual page 5

NOTE TO ELECTRICIAN: The armored cable leads
supplied with the appliance are UL-recognized for
connection to larger gauge household wiring. The
insulation of the leads is rated at temperatures much
higher than temperature rating of household wiring. The
current carrying capacity of the conductor is governed by
the temperature rating of the insulation around the wire,
rather than the wire gauge alone.
Model and Serial Number Location
The serial plate is located along the interior side trim of
the oven and visible when the door is opened.
When ordering parts for or making inquires about your
oven, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your oven.
5. Cabinet Installation
_The wall oven can tip when the door is
open. The mounting brackets supplied with the
wall oven must be attached to the cabinet and the
appliance to prevent tipping of the wall oven and
injury to persons.
Mounting Brackets Installation Instructions
1. Unpack the wall oven. Remove the bottom trim taped
on the oven side panel. Find the 2 mounting brackets
and screws included in the literature package.
2. Install the mounting brackets in the wall cabinet as
shown on Figure 5. Note: To prevent damage to
cabinet, it is recommended to drill 1/16" (0.16 cm) dia.
pilot holes before installing the mounting brackets.
Single Wall Oven
Serial Plate Location
Double Wall Oven
Serial Plate Location
Heavy Weight Hazard
Use 2 or more people to move and install wall oven.
Failure to follow this instruction can result in injury
or damage to the unit.
_F see figure 1_
kX,
Mounting Brackets _ H
see figure 1
22 3/16" *
(56.4 cm)
Single Wall ovens
L_F see figure 2_
kk"
I I T
Mounting Brackets _ H
see figure 2
43 5/8" *
(110.8 cm)
Double Wall ovens
• If wood shims are installed please calculate this
dimension from the top of the shim to the middle of
the mounting bracket.
Figure 5