Connections - D-Link DFL-700 - Security Appliance Product Manual

Connections

Click on Status in the menu bar, and then click Connections below it. A window will
appear providing
information about
content of the state table.
The state table shows
the last 100 connections
opened through
firewall. Connections are
created when traffic is
permitted to pass via the
policies.
Each connection has
two timeout values, one
in each direction. These
are updated when the
firewall receives packets
from each end of the
connection. The
shown in the Timeout
column is the lower of the
two values.
Possible values in the
State column include: TCP_CLOSE, TCP_OPEN, SYN_RECV, FIN_RECV, and so on.
The Proto column can have:
TCP - The connection is a TCP connection.
PING - The connection is an ICMP ECHO connection.
UDP - The connection is a UDP connection.
RAWIP - The connection uses an IP protocol other than TCP, UDP, or ICMP.
The Source and Destination columns show which IP and port on the source interface the
connection is coming from, and which interface and port number the connection is going to.
the
the
value
74