Add A New Static Route; Remove A Static Route - D-Link DFL-700 - Security Appliance Product Manual

Add a new Static Route

Follow these steps to add a new route.
Step 1. Go to System and Routing.
Step 2. Click on Add new in the bottom of the routing table.
Step 3. Choose the interface that the route should be sent through from the dropdown
menu.
Step 4. Specify the Network and Subnet mask.
Step 5. If this network is behind a remote gateway, enable the checkbox Network is
behind remote gateway and specify the IP of that gateway.
Click the Apply button below to apply the settings or click Cancel to discard changes.

Remove a Static Route

Follow these steps to remove a route.
Step 1. Go to System and Routing.
Step 2. Click the Edit corresponding to the route you would like to remove.
Step 3. Check the checkbox named Delete this route.
Click the Apply button below to apply the settings or click Cancel to discard changes.